Learn

Install your LeveLite.

Installation is pretty simple. Mount the sensor, mount and connect the lights, plug it in.

1. Be Safe

Make sure you have the time and the people you need for a safe installation. Also, the sensor uses a laser. Do not look into the source when powered on.

2. Mount the sensor

Attach the sensor to the inside of the roof so the cable is pointed directly at the side of the bin so the sensor is aimed straight down. Be sure the surface of the bin roof is clean to ensure strong contact.

3. Feed the sensor connector to the outside.

Feed the cable through a roof ridge or a hatch. We have extensions if your bin doesn't have a short, straight shot.

4. Start connecting

Connect the sensor to the top light track. The connectors only attach in one direction.

5. Attach the tracks

Any loose wire can be tucked behind the light track. Attach the track as high up under the roof as possible.

6. Keep connecting

Start connecting tracks together, tucking any extra cable behind the track, and attaching the tracks to the bin.

7. Inject power

At least two tracks up from the bottom, connect the power tee. You can tuck the power cable behind the track down to the bottom. We have power extensions if you have a large number of tracks so that power can be injected further up the bin.

8. Power Up

Attach the power supply to the bin and plug it in. Put some electrical tape or silicone sealant on the bottom open connector.

Got a bin in mind?

Tell us about your setup.

Send us a few details about your bin and we'll help you figure out the best mounting approach.